dinoangelo Posted July 16, 2020 Share Posted July 16, 2020 hi guys any good suggestions , on carrying this model to layout , i don't want to break anything, i 1st was lifting up directly under both sets of drivers which can be akward placing on track i have also just carried by approximate middle of boiler just above middle of both sets of drivers .just dont want to break anything need some kind of carrier/loader any reccomendations do's or dont's on this its not that it's heavy just a little long and being articulated thanks Quote Link to comment Share on other sites More sharing options...
Rayman4449 Posted July 16, 2020 Share Posted July 16, 2020 I normally lift the engine with one hand from under the front of the boiler and the other inside the cab. Alternately I will sometimes use one hand in the cab and rock the engine to one side and lift from the middle providing some support for front engine set. Quote Link to comment Share on other sites More sharing options...
Jerry B44 Posted July 17, 2020 Share Posted July 17, 2020 I built a carrier for the engine. Just 1/4" ply with some strips the right size to raise it off the rails. I changed it to velcro strips. Push it about halfway on the track, then lift the cab and remove the carrier. I did one for my Challenger also. Quote Link to comment Share on other sites More sharing options...
dinoangelo Posted July 18, 2020 Author Share Posted July 18, 2020 thanks for both suggestions , was thinking of making a carrier / loader just wish axles were free rolling like (USA trains hudson ) thanks again, dino Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.