Search the Community
Showing results for tags 'Hudson'.
-
Here is a collection of photos of the MTH Hudson (One Gauge): For more info see the following pages: Additional Photos and Product information page: http://www.rayman4449.com/MTH_Hudson.htm Repairs/Modifications page: http://www.rayman4449.com/MTH_Hudson_mods.htm These pages are accessible off my home page at: www.rayman4449.com (Click the photo to enlarge) Most recent Upgrade to Protosound 3 with upgraded speaker and sound (other whistles available):
-
MTH 1 Gauge No.5405 J3a Hudson - 70-3019-1 for sale at Ebay: http://www.ebay.com/itm/191922857605?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
-
Hi guys, A while back, I traded a locomotive for a stripped out MTH Hudson. I'm having an issue when I run it, however. When I am running through Aristo wide radius turnouts (trailing points), the sliders drop down between the rails and jam. Obviously, the gauge is a little wide there. Should I attempt to correct the gauge or should I remove the sliders? Also, I note that the lead drivers do not fully touch the rails, and again, I suspect the sliders are the culprit. Any ideas? Thanks, Mark
-
From the album: Rayman4449's photos
-
From the album: Rayman4449's photos
-
From the album: Rayman4449's photos
-
Wanted to share that I do have a replacement motor available for the USA Hudson for $175.00. This motor addresses issues with the original: Operates at a higher top speed when run at max track voltage.This addresses the complaint by some that it's top speed was too low.Has ball bearings on both ends of the motor for lifetime reliability.Video of a USA Trains Hudson motor with a failed bearing on the worm gear end: (With the upgrade motor you will never have this) http://www.rayman4449.com/USA_Trains_Hudson_Motor_Failure_101910_0001a.JPG Given that USA Trains has been out of stock on these motors for a couple of years this helps provide an option. Raymond
- 3 replies
-
- USA hudson
- Hudson
-
(and 3 more)
Tagged with: