Milwaukee Roadster Posted December 23, 2016 Share Posted December 23, 2016 Hi. First post here. Just bought a USA Trains "starter set" to use under the tree. All went very well until I powered up the layout. The locomotive (EMD NW-2 Switcher) does NOT run. No lights, no motion, not even the slightest '"hum" from the unit. I called the (internet) dealer but no answer so I'm hoping I can get some help via this site. I looked for an on/off switch on the loco but didn't see one. Just to be clear... DC voltage IS CONFIRMED at the power pack AND at the rails. Again, no lights, no hum, no motion from the locomotive. Any suggestions? Thanks in advance and a Merry Christmas and Happy Holidays to all. Quote Link to comment Share on other sites More sharing options...
Milwaukee Roadster Posted December 23, 2016 Author Share Posted December 23, 2016 Got it. Found the on/off switch inside the loco. Quote Link to comment Share on other sites More sharing options...
Rayman4449 Posted December 23, 2016 Share Posted December 23, 2016 Good deal and have a great holiday as well Quote Link to comment Share on other sites More sharing options...
Sean Posted December 27, 2016 Share Posted December 27, 2016 Good... they're under the front radiator cover. Quote Link to comment Share on other sites More sharing options...
Garvin Trains 01 Posted November 21, 2020 Share Posted November 21, 2020 I've got a USA Trains EMD NW-2 that only runs on one engine (forward). Power applied to the rear pick-ups provided power to the front trucks so power does not seem to be a problem. Any thoughts? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.